Clothes Dryer Vent Booster Misc 9460DJ

• The Clothes Dryer Vent Booster can reduce drying times and save energy for clothes dryers with a long exhaust line
• When the dryer exhaust has a long run to the dryer vent it increases drying time, electricity usage and wear and tear on the dryer
• Assembly includes pressure switch and 10' line cord
• Easy installation to dryer vent
• Install right next to dryer or anywhere in the line. No Lint Trap Needed if installing next to the dryer! No Lint Trap means no automatic lint build-up.
• This DryerJet model has Rubber Feet installed to stand on the floor or a shelf. Can also mount horizontally. See instructions.
• No on-site wiring
• Turns on and off automatically when the dryer turns on and off
• Air pressure sensing switch (PS-35) is mounted on dryer booster fan
• Pre-wired at factory with 10-foot line cord
• Includes probe
• Just plug it in!
• Ball bearing motor out of air stream
• No lint buildup on motor and no place to collect
• DryerJet has been tested by an independent lab at Florida International University
• The DryerJet tested excellently on runs over 100 effective feet*
• Runs up to 50' of duct and up to four 90° bends

* Effective feet computation: Each foot of straight pipe = 1 foot. Each 90° bend = 5 feet. Each 45° bend = 2.5 feet.